PRESSCONTROL

PRESSURE FLOW SWITCH

Starts and stops the pump depending on opening and closing of the outlets.

Stops the pump in case of water shortage and protects it from dry running.

Can be installed on surface and submersible pumps.

No need for an expansion tank, check valve, filter or fittings.

Maintenance free.

	PRESSCONTROL	PRESSCONTROL R	PRESSCONTROL UP	PRESSCONTROL UP R
Single-phase mains voltage	230 Vac	230 Vac	115/230 Vac	115/230 Vac
Acceptable voltage fluctuation	+/- 10%	+/- 10%	+/- 10%	+/- 10%
Frequency	50/60 Hz	50/60 Hz	50/60 Hz	50/60 Hz
Current max	10 A	10 A	10 A	10 A
Power max at 115V			0,75 kW (1 HP)	0,75 kW (1 HP)
Power max at 230V	1,5 kW (2 HP)	1,5 kW (2 HP)	1,5 kW (2 HP)	1,5 kW (2 HP)
Protection degree	IP 65	IP 65	IP 65	IP 65
Operating pressure max	12 bar	12 bar	12 bar	12 bar
Operating temperature max	65 °C	65 °C	65 °C	65 °C
Minimum flow	~1 l/min	~1 l/min	~1 l/min	~1 l/min
Male connections	Gc 1”	Gc 1”	Gc 1”	Gc 1”

It differs from Presscontrol because it can be powered at both 115 Vac and 230 Vac and is equipped with automatic reset and antijamming

function.

AUTOMATIC RESTARTS

In case of stopping due to a water shortage, the device will automatically make 10 double attempts to rearm over the 24 hours following

the failure, each lasting approximately 5 seconds to allow the pump and the system to reload if possible.

The user can try to rearm the device at any time by pressing the Restart button.

ANTI-JAMMING FUNCTION

If for any reason the pump remains idle for 24 consecutive hours, the device will start the pump for about 5 seconds.

It differs from the Presscontrol in the hydraulic part, modified to allow the adjustment of the restart value.

The restart adjustment function can also be combined with the Presscontrol UP.